10G CWDM SFP+/ XFP Fiber Optic Transceiver Single Mode With LC Interface

Product Description

10G CWDM SFP+/XFP Transceiver Modules with Built-in Digital Diagnostic Functions

10G CWDM SFP+/XFP transceiver modules are small form factor pluggable module for serial optical data communications. It is designed for single mode fiber and operates at a nominal wavelength of CWDM wavelength. There are 18 center wavelengths available from 1270 nm to 1610 nm, with each step 20 nm. A guaranteed minimum optical link budget of 14 dB is offered. Sopto supplies OEM service and Third-Party(Cisco, Juniper, HP, Dell etc.) compatible fiber optic transceivers.

Product Features

● Single +3.3 V Power Supply

● Built-in digital diagnostic functions

● 2G/4G/8G/10G Fibre Channel compliance

● Transmission distance up to 80km over SMF

● Power Budget up to 10dB, 14dB, 16dB, 23 dB

● Supports Multi-Protocol 8.5Gb/s, 9.95Gb/s to 11.3Gb/s bit rates

● Class 1 Laser International Safety Standard IEC-60825 Compliant

● Uncooled 18-λ CWDM DFB/cooled EML LD: from 1270 nm to 1610 nm

● Can be used with single-fiber CWDM system or dual fiber CWDM system

● Operating Case Temperature: Standard: 0~70°C; Extended: -20~85°C; Industrial: -40~85°C

Compliant

● RoHS-6

● IEEE 802.3ae 10GBASE

● SFF-8431, SFF-8432, SFF-8472

Sopto fiber optic transceiver took the first lead to pass the ISO9001 quality system, the requirements of European CE, RoHS

Pin Assignment

Diagram of Host Board Connector Block Pin Numbers and Name.

Pin Function Definitions

Note 1. The module ground pins shall be isolated from the module case.

2. This pin is an open collector/drain output pin and shall be pulled up with 4.7K-10Kohms to Host_Vcc on the host board.

3. This pin shall be pulled up with 4.7K-10Kohms to Vcc in the module.

4. This pin is an open collector/drain output pin and shall be pulled up with 4.7K-10Kohms to Host_Vcc on the host board.

SFP Module EEPROM Information and Management

The SFP modules implement the 2-wire serial communication protocol as defined in the SFP -8472.

The serial ID information of the SFP modules and Digital Diagnostic Monitor parameters can be accessed through the I2C interface at address A0h and A2h. The memory is mapped in Table 1. Detailed ID information(A0h) is listed in Table 2. And the DDM specification at address A2h. For more details of the memory map and byte definitions, please refer to the SFF-8472, “Digital Diagnostic Monitoring Interface for Optical Transceivers”. The DDM parameters have been internally calibrated.

Table 1. Digital Diagnostic Memory Map (Specific Data Field Descriptions)

Table 2. EEPROM Serial ID Memory Contents (A0h)

Mechanical Dimensions

All-optical transceivers are RoHS compliant and could be 100% compatible with branding equipment, such as Cisco, Extreme, Juniper, HP, H3C, Linksys, Huawei, Alcatel-Lucent, Foundry, Nortel, Force10 etc.

Applications

● SONET OC-192 / SDH STM-6

● OTN ITU-T G.709

● 10GBASE-SR/LR/ER/ZR Ethernet

● 10X/8X/4X/2X/1X Fibre Channel

● CWDM Networks

Ordering Information